Manual Adjust / Continuous Adjust; Palette; Hide Graphics; Figure 9.20 Palette Dialog Box - FLIR ThermaCAM P20 Operator's Manual

SEE ALSO: For more information about object parameters, see section 16 – Thermographic
measurement techniques on page 80.
9.2.4.4

Manual adjust / Continuous adjust

Point to Manual adjust and press the joystick to put the camera in manual adjust
■
mode. You can now change level and span by first pressing the C button repeat-
edly (to change the function of the joystick to level/span), and then change
level or span by moving the joystick up/down and left/right, respectively
Point to Continuous adjust and press the joystick to put the camera in automatic
■
mode, continuously optimizing the image for best level and span
SEE ALSO: For more information about the Level/Span command, see section 9.2.4.3 – Level/Span
on page 46.
9.2.4.5

Palette

10392003;2

Figure 9.20 Palette dialog box

Point to Palette and press the joystick to display a dialog box where you can
change the color palette.

Figure 9.21 Explanations of the Palette dialog box

Label
Palette
Inverted
9.2.4.6

Hide graphics

Point to Hide graphics and press the joystick to hide all on-screen graphics (e.g.
result table, status bar etc.). To display the graphics again, press the joystick or the
C button.
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004
Value
Configuration-dependent
Yes
■
No
■
9.2 – Menu system
Comments
Move the joystick left/right to
change the palette.
Move the joystick left/right to
reverse the current palette.
47