Changing Level & Span; Changing Level; Changing Span - FLIR ThermaCAM E4 Operator's Manual

Step
3
4
5
6
7.6 Changing level & span
7.6.1

Changing level

Step
1
2
3
For more information about level, see section 9.4.3 – Manual adjust/Automatic adjust
on page 34.
7.6.2

Changing span

Step
1
2
3
For more information about span, see section 9.4.3 – Manual adjust/Automatic adjust
on page 34.
Publ. No. 1 558 017 Rev. a62 – ENGLISH (EN) – August 19, 2004
Action
The final result should look like this:
<Recommendation>
Check connections
Check cables
Check gaskets
Check mountings
Save the file to Desktop and change the file extension to .tcf.
Transfer the *.tcf file to your PDA. You can also move the file to the camera using
ThermaCAM QuickView.
Beam the file from the PDA (or laptop) to the camera.
You can now add any of the values to an infrared image by pointing to Image
description on the File menu.
Action
Press MENU/YES to display the vertical menu bar.
Point to Manual adjust on the vertical menu bar and press MENU/YES.
Press the navigation pad up/down to change the level. An arrow pointing upwards
or downwards will be displayed.
Action
Press MENU/YES to display the vertical menu bar.
Point to Manual adjust on the vertical menu bar and press MENU/YES.
Press the navigation pad left/right to change the span. Two arrows pointing away
from each other or towards each other will be displayed.
7.6 – Changing level & span
17