Freezing & Unfreezing An Image; Saving An Image; Creating & Changing An Isotherm - FLIR ThermaCAM P20 Operator's Manual

6.3 – Creating & changing an isotherm
6.2.3 Freezing & unfreezing an image
Step
1
2
3
6.2.4

Saving an image

Step
1
2
3
SEE ALSO: For more information about saving images, see section 9.2.2.2 – Save on page 41. .
6.3 Creating & changing an isotherm
Step
1
2
SEE ALSO: For more information about creating & changing an isotherm, see section 9.2.3.2 – Add
isotherm on page 42.
12
Action
Press and hold down the A button for one second to adjust the focus.
Briefly press the A button to autoadjust the camera.
Briefly press the S button to freeze the image. To unfreeze the image, press
the S button once again.
Action
Press and hold down the A button for one second to adjust the focus.
Briefly press the A button to autoadjust the camera.
Do one of the following:
Press and hold down the S button for a few seconds to save the image
■
Point to Save on the File menu and press the joystick
■
Action
Press the joystick to display the horizontal menu bar.
Point to Add isotherm on the Analysis menu and press the joystick. An isotherm
will now be added to your image. The isotherm levels will be displayed in the
result table in the top right corner of the screen.
You are now in edit mode and can change the isotherm levels by moving the
joystick up/down. To leave the edit mode, press the C button twice. You can
also leave the edit mode by holding down the joystick for a few seconds, which
will display a shortcut menu.
Publ. No. 1 557 536 Rev. a35 – ENGLISH (EN) – January 20, 2004