Error Messages - Cabletron Systems SmartSwitch Router Reference Manual

Recommended Action:
Check command and re-enter.
-CLI-W-PORTBAD Port '<port_name>' failed self-test - ignoring
Explanation:
During system initialization, this message is displayed if the a particular port failed the
self-test. The failed port is ignored.
Recommended Action:
Contact Cabletron Technical Support. You may have a bad port on one of your
modules.
-CLI-W-PORTNOTFOUND port '<port_name>' does not exist - ignoring
Explanation:
The user is refering to a port on a module that is not currently available on the system.
This is simply a warning message indicating that the command the user specified will
not have an effect on the port since the module doesn't exist.
Recommended Action:
Verify port exists in SSR before attempting to configure the specified port.

Error Messages

-CLI-E-BADMCASTADDR Multicast address required: '<IP_address>'
Explanation:
The command requires a multicast address as a parameter but the user entered a non-
multicast address.
Recommended Action:
Specify a multicast address.
4 - 2
Chapter 4: CLI Error Messages
SSR-8 Error Reference Manual