Cabletron Systems SmartSwitch Router Reference Manual page 192
Error reference manual
Hide thumbs
Also See for SmartSwitch Router:
- User's reference manual (338 pages) ,
- User's reference manual (207 pages)
Table of Contents
Advertisement
Recommended Action:
Configure the system to run diagnostics, then reboot. Note the diagnostics messages.
If any NIA failures are detected, the Control Modules may be bad and needs replacing.
-SYS-E-PORTBUSWRITE Port bus write error at address 0x<hex_value>
Explanation:
Control Module may have a hardware problem.
Recommended Action:
Configure the system to run diagnostics, then reboot. Note the diagnostics messages.
If any NIA failures are detected, the Control Modules may be bad and needs replacing.
-SYS-E-XBARTMOUT Transmit timeouts to Xbar (destCEPs=0x<hex_value>)
Explanation:
Control Module may have a hardware problem.
Recommended Action:
Configure the system to run diagnostics, then reboot. Note the diagnostics messages.
If any NIA failures are detected, the Control Modules may be bad and needs replacing.
Fatal Messages
-SYS-F-2MANYCPUS too many CPUs, detected %d, architectural limit <num-
ber>
Explanation:
More than the architectural number of redundant Control Modules were detected.
Recommended Action:
Remove all extra Control Modules.
29 - 8
Chapter 29: SYS Error Messages
SSR-8 Error Reference Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the SmartSwitch Router and is the answer not in the manual?
Questions and answers