Table of Contents
Advertisement
Side View
24 3/4"
26 3/4"
26"
4"
*Finished Width
7 1/2"
7"
5"
Locate Grounded
84 1/2" max
83 1/2" min
Finished
Opening
Locate Water
Supply Within
the Shaded
Area Below
5"
3 1/2"
* 36" Min. for a flush installation into an enclosure.
* 35-1/2" Min. for a semi-flush installation into an enclosure.
Note: Additional cutout width may be required when side panels are
used. Add side panel thickness to the finished cutout width to
calculate rough-in width. See installation examples on page 4.
Front View
10 3/4" Max
35" Case
10" Min
36" Overall"
84 1/2" Max
83 1/2" Min
73-1/2"
Wall View
(not to Scale)
Electrical outlet
Within Solid
74" From
Area Above
Floor to
Bottom of
Electrical Area
5"
3 1/2"
Custom Panel Dimensions
36" Bottom Mount Refrigerators
ZIC36N Bottom Mount Refrigerator
Design Information
Designed to be installed flush or semi-flush with
surrounding cabinetry. Cutout dimensions, clearances
and side panel sizes are determined by the many
installation options available. Side panels must be used
whenever the sides of the refrigerator will be exposed.
Side panels are not required when refrigerator is
installed into an enclosure or between pantry and oven
cabinets. IMPORTANT - Side panels, 1/2" minimum
thickness are required when using FRAMELESS
CABINETS.
• Field installed custom panels, Lexan
steel panels are required. The door panels and grille
panel sizes vary to accommodate the kit being used.
• The supplied toekick is vented and must remain
unobstructed for proper air circulation.
Optional Panel Kits:
• ZWBC36: Black Lexan
• ZWWC36: White Lexan
• ZWSC36: Stainless Steel Panel Kit
Optional Custom Trim Kits:
• ZKHC1: For installation of a custom handle of your
choice onto 1/4" Panels.
• ZKTC36L or ZKTC36R: For installation of 3/4" thick
custom panels.
• ZKHTC1: For installation of a custom handle of your
choice onto 3/4" thick panels. (This kit must be used in
combination with ZKTC36L or ZKTC36R.
• ZKHCSS1: Tubular Stainless Steel handles for 1/4"
thick panels.
• ZKHTCSS1: Tubular Stainless Steel handles for 3/4"
thick panels.
• ZGC2: 1/4" grille panel frame side pieces for 83-1/2
and 84-1/2" installation heights. Factory set height is
84".
Additional Specifications
• A 115 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install a
properly grounded 3-prong electrical receptacle
recessed into the back wall. Electrical must be
located on rear wall as shown.
• Water line can enter opening through the floor or
back wall. The water line should be 1/4" O.D. copper
tubing between the cold water line and water
connection location, long enough to extend to the
front of the refrigerator. Installation of an easily
accessible shut off valve in the water line is
recommended.
Clearances:
• If the refrigerator is to be installed in a corner:
A 4" clearance is required on the hinge side for a 90°
door opening and access to fresh food drawers. A 10"
clearance is required on the hinge side for removal of
pans.
®
or stainless
®
Panel Kit
®
Panel Kit
7
Advertisement
Table of Contents
