Table of Contents
Advertisement
Kit
Right hand door swing models are illustrated in these
Contents
instructions. Follow these instructions for left hand
models.
This kit provides for the installation of Stainless Steel
handles on 3/4" thick decorator door panels. The door
extrusions allow these custom handles to be secured
to the door structure, rather than to the custom panels.
• Select fresh food extrusion for your model, discard
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 1/8", 9/32" bits
• Custom door panels
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
Parts List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
C. Freezer drawer handle extrusion
D. 2 Stainless tubular handles
E. 4 Handle standoffs
F. 6 Screws for handle standoffs
G. 6 Set screws (4 required, 2 extra)
H. 3/32" Allen wrench for set screws
Before
• 3/4" custom panels must be routed to accommo-
you begin:
• Follow the instructions in the ZKTC36R (or
• Continue the instructions in the ZKTC36R (or
other fresh food extrusion.
(4 required, 2 extra)
date these handle extrusions. Rout the panels
as illustrated, 1/4" deep, and 1-13/16" wide, top
to bottom on the handle side.
ZKTC36L) to install trim onto the fresh food and
freezer drawer. Discard the handles supplied
with that kit.
ZKTC36L) trim kit to install support brackets to
the bottom of the fresh food and freezer panels.
ZKHTCSS1 for 3/4" panels
Tubular Stainless Steel Handles
This kit must be used in combination with ZKTC36, trim
kit.
Note: It is best that 2 people install this kit.
A
B
C
D
E
H
Fresh Food Panel
1-13/16"
Back Side
1/4" Max.
Handle Side
CAUTION: Optional final appearance depends on
careful routing depth. Do not exceed 1/4" routing depth.
F
G
Freezer Drawer Panel
Handle
End
1-13/16"
Back Side
36
Advertisement
Table of Contents
