1/4" Framed Panel Dimensions; 3/4" Overlay Panel Dimensions - Monogram ZIFS360NHRH Installation Instructions Manual

Design Guide - Standard Installation

1/4" FRAMED PANEL DIMENSIONS

If you choose to install framed panels, they must be cut to
the dimensions shown. The panels will slide into the frame
on the door and grille.
If the custom panel is less than 1/4" thick and if it fits
loosely in the door frame, it can be backed up with a piece
of filler material or foam tape to improve the fit.
IMPORTANT NOTE: Maximum weight for door panel
is 67 pounds. Maximum total weight for assembled grille
panel is 11 pounds.

3/4" OVERLAY PANEL DIMENSIONS

For a more custom appearance, overlay panels may
be installed on trimmed models. The overlay panel must
be secured to a 1/4" thick backer panel which slides
into the trim. A spacer panel 0.10" thick must be placed
between the overlay and backer panel.
IMPORTANT NOTE: Maximum total weight for assem-
bled door panel is 67 pounds. Maximum total weight for
assembled grille panel is 11 pounds.
Assemble the panels with glue and screws.
• Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
• Center the spacer and backer panel on the overlay
panel and secure with glue and screws. Screws must
be countersunk into the backer panel.
Framed Panel Dimensions
A (Width)
1/4" Framed Panel 33-7/8"
Overlay Panel Dimensions
A (Width)
1/4" Backer Panel 33-7/8"
0.10" Spacer Panel 32-1/2"
3/4" Overlay Panel 34-1/8"
Door
B (Grille Height) C (Door Height)
8-7/8" 69-5/16"
B (Grille Height) C (Door Height)
8-7/8" 69-5/16"
7-5/8" 67-15/16"
9" 69-9/16"
NOTE: Left-to-right offset is not always equal
to top-to-bottom offset.
9
5/16"
Trim
Reveal
1/4"
Panel