Related Manuals for Monogram ZICS36N RH
Summary of Contents for Monogram ZICS36N RH
- Page 1 ® GE Monogram Installation Instructions Stainless Steel Bottom Mount Built-In Refrigerators Models ZICS36N RH ZICS36N LH...
-
Page 2: Table Of Contents
Proper installation is the responsibility of the service technician. installer. Product failure due to improper installation is not covered under the GE For Monogram local service in your area, 1-800-444-1845. Appliance Warranty. See the Use & Care Guide for warranty information. -
Page 3: Flush Or Semi-Flush Enclosure Installations
The case trim creates a into the surrounding cabinetry. frame around the opening. Side Panels Requirements: Monogram built-in refrigerators can be • Side panels are not required whenever the installed flush with typical 24-3/4" deep refrigerator is installed into an enclosure or cabinetry. -
Page 4: Installation Examples
Design Information 36" Stainless Bottom Mount Refrigerators Side panels are required whenever the sides Therefore, the rough-in dimensions must of the refrigerator will be exposed. allow for side panel thickness. In both a flush and semi-flush installation, the finished 1/2" to 3/4" side panels are normally set into dimension, (the width of the opening after place and fastened to adjacent cabinetry or to side panels are installed), must accommodate... -
Page 5: Installation Preparation
Installation Preparation 36" Stainless Bottom Mount Refrigerators ZICS36N RH Product Handle on the left side, the door swings left to Dimensions right. ZICS36N LH Handle on the right side, the door swings right to left. A – 36" outside trim width B –... -
Page 6: Grounding The Refrigerator
Installation Preparation 36" Stainless Bottom Mount Refrigerators IMPORTANT - (Please read carefully) Grounding FOR PERSONAL SAFETY, THIS APPLI- ANCE MUST BE PROPERLY GROUNDED. Refrigerator The power cord of this appliance is equipped with a three-prong (grounding) plug which mates with a standard three-prong (ground- ing) wall receptacle to minimize the possibil- ity of electric shock hazard from this appli- ance. -
Page 7: Tools Required
Installation Preparation 36" Stainless Bottom Mount Refrigerators • Appliance Hand Truck • Tinsnips to cut banding • Drill and appropriate bits Tools • Tubing cutter • Stepladder • 7/16" socket with 3" extension Required • 7/16" open-end wrench • Bucket for ratchet •... -
Page 8: Step 2: Install Water Line
Installation 36" Stainless Bottom Mount Refrigerators • A cold water supply is required for automatic icemaker operation. The water pressure Step must be between 20 and 120 p.s.i. Install • Route 1/4" OD copper tubing between house cold water line and the water connec- Floor Water tion location. -
Page 9: Step 3: Install Side Panels
Installation 36" Stainless Bottom Mount Refrigerators • If you choose to use 1/4" side panels, they • Side panels are required whenever the sides of the refrigerator will be exposed and when should be inserted into the case trim as S tep illustrated. -
Page 10: Step 4: Install Anti-Tip Brackets
Installation 36" Stainless Bottom Mount Refrigerators Note: If you are CAUTION Step WARNING ANTI-TIP PRECAUTIONS installing under a 2 x 4 The refrigerator is heavy at the top and must be soffit, attach brackets Block 83-1/2" secured to prevent the possibility of tipping to wood block before 36"... -
Page 11: Step 7: Connect Water Supply
Installation 36" Stainless Bottom Mount Refrigerators Check to be sure that refrigerator power cord is not plugged into the wall outlet. Step • Locate and bring copper tubing to the front Connect of the cabinet. • The copper tubing should be just long Water enough to reach the coupling. -
Page 12: Step 10: Install Toekick
Installation 36" Stainless Bottom Mount Refrigerators • A standard toekick is supplied. Install with 2 screws provided, adjust to desired height and Step tighten screws. Install Important: The vented toekick must remain unobstructed for proper air circulation and operation. Toekick •... -
Page 13: Zfc1 Trim Kit For Side To Side Installation
ZFC1 Trim Kit Side to Side Installation For the ultimate in convenience, install two refrigerators side to side. This trim kit includes 6 foam spacer pads to fill the gap between the refrigerator side case trims. For a finished appearance, a trim strip is provided to conceal the side case trim of the two refrigerators. -
Page 14: Problem Solving
Notes 36" Stainless Bottom Mount Refrigerators... - Page 15 • Check to be sure that fuse or circuit breaker is turned on. If any of these problems persist: Call for Monogram local service in your area, 1-800-444-1845. Cleaning the Stainless Steel Refrigerator Stainless Steel has some unique cleaning characteristics.
- Page 16 Note: While performing installations described in this book, safety glasses or goggles should be worn. To obtain specific information concerning any ® Monogram product or service, call GE Answer Center consumer information service at 800.626.2000—any time, day or night. For Monogram local service in your area, call 1-800-444-1845.