Step 3 Install Custom 3/4" Door Panel And Handle - Monogram Fresh Food Custom ZIFI240 Installation Instructions Manual

STEP 3 INSTALL CUSTOM 3/4"
DOOR PANEL AND
HANDLE
models only)
3/4" Overlay Panel Dimensions
Model ZIFI240 and ZIBI240 require
a field-installed overlay door panel.
• The overlay panel must be
secured to a 1/4" thick backer
panel that slides into the trim. A
.10" thick spacer panel must be
placed between the overlay and
backer panel.
• A custom handle of your choice,
supplied by your cabinetmaker,
must be installed on this overlay panel. Countersink all
screws into the backer panel. Screws cannot protrude
from the backer panel.
IMPORTANT NOTE: Maximum total weight for custom
door panel is 25 pounds.
3/4" Overlay Panel Dimensions (in inches)
B 1/4" Backer
0.10" Spacer 22-1/2"
3/4" Overlay 23-5/8"
A
Assemble overlay panels with glue and screws.
• Center spacer panel on the backer panel, left to right and top
to bottom. Secure the panels with glue.
• Center the spacer/backer panel on the overlay panel.
Secure with glue and screws. Countersink all screws into
the backer panel.
Overlay Panel
Spacer Panel
Backer Panel
31-1000642
Installation Instructions
(ZIFI240 and ZIBI240
Overlay
Panel
Door
1/4"
.10 Inch
Backer
Spacer
Panel
A (Width) B (Height)
23-3/16" 29-9/16"
29-1/16"
30"
STEP 3 INSTALL CUSTOM 3/4"
DOOR PANEL AND
HANDLE
models only)
Custom Panel Hinge Routing Dimensions
Use a 3/4" router bit to cut a notch into the back side of
the assembled panel 3/8" toward the front of the overlay
panel, 3/4" deep and 7/8" wide.
3/4"
7/8"
3/8"
7/8"
3/8"
3/4"
Install custom door panel and handle:
• Open door to 90°.
• Remove 5 screws holding trim; lift off trim.
Retain screws.
• A custom handle of your choice, supplied by your
cabinetmaker, must be installed onto the overlay panel
before the panels are slid into the trim. Countersink all
screws into the backer
panel. Screws cannot
protrude from the
backer panel.
(ZIFI240 and ZIBI240
NOTE: Right-hand models
illustrated. Cut notches on the
opposite side for left-hand fresh
food door swing models
ZIFI240 and ZIFS240.
Back side
of custom
panel
NOTE: Right-hand
models illustrated. Follow
the same instructions
on the opposite side for
left-hand fresh food door
swing models ZIFI240
and ZIFS240.
Screws Must
Be Countersunk
Into Panel
Handle
Custom
Door Panels
13