Table of Contents
Advertisement
Step 9
• Connect refrigerator power cord plug to a properly
Connect
power
• Check to make sure power to refrigerator is on by
Step 10
If you are using 3/4" thick custom panels, SKIP THIS
Mount
STEP. See Dimensions and Specifications for grille
Top Grille
panel sizes. Order ZKTC36L or ZKTC36R and follow the
Panel
installation instructions packed with the kit.
The grille panel frame is factory assembled for an 84"
installation height. If installation height varies, order
ZGC2 trim kit which provides optional side trim pieces
for 83-1/3" and 84-1/2" heights.
Cut 1/4" thick custom panel to fit the frame,
35-1/8" wide, 8" deep (for an 84" installation).
• For shipping purposes, the top case trim is secured at
To raise case trim to 84-1/2" or to lower to 83-1/2"
installation height:
• Loosen 2 screws on both sides and raise the top or
• Tighten all 4 screws.
To insert custom grille panel into the frame:
• Remove screws (2 on each top corner) and "L"
• Slide panel into the frame and reassemble.
• Mount the grille panel by dropping into slots on the
Important : Maintain 1-1/2" min. gap between top of doors and
bottom of panel frame.
Step 11
• A standard toekick is supplied. Install with 2 screws
Install
provided, adjust to desired height and tighten screws.
Toekick
Important: The vented toekick must remain unobstructed
for proper air circulation and operation.
grounded receptacle, accessible through the top left
side of the grille opening.
opening refrigerator door to see if interior lights are
on.
84" installation height and must be adjusted.
lower case trim to meet soffit height or to the top of
adjacent cabinets.
brackets on each side.
case trim.
1-1/2"
min.
gap
Installation
36" Bottom Mount Refrigerator
Screws
Top
Case
Trim
Raise To
Installation
Height
17
Advertisement
Table of Contents
