Table of Contents
Advertisement
Step 4
Install
panels
Fresh Food Panel:
• Open the door fully.
• Carefully drill 4 starter holes using a small drill bit,
• Install original screws through the trim and into the
• Drill 4 starter holes through the hinge side and 4
Freezer panel:
• Place the 3/4" thick panel onto the door with the
• Turn door over, panel side down. Attach the panel to
• Reinstall light switch plate to the bottom trim with
• Place the 3/4" thick panel on the bottom trim with
support bracket tabs inserted into slots. Push the
panel back against the steel door, flush with hinge
side trim.
through the backside of the trim at the top.
panel to secure the panel to the door.
through the bottom trim. Install original screws.
support bracket tabs inserted into slots. The sides of
the panel should be flush with trim on both sides.
the sides and bottom by installing screws through the
back of the trim and into the wood panel.
original screws.
ZKTC36L/ZKTC36R Trim Kit
3/4" Custom Panels
Insert support bracket tabs
into slots on bottom trim
Inside Freezer Drawer
Light Switch Plate
25
Advertisement
Table of Contents
