1/4" Framed Panel Dimensions - Monogram ZIS360N Installation Instructions Manual

Design Guide
1/4" FRAMED PANEL DIMENSIONS
If you choose to install framed panels, they must be
cut to the dimensions shown. The panels will slide
into the frame on the door and grille.
Non-Dispenser Models
If the custom panel is less than 1/4" thick and it fits
loosely in the door frame it can be backed up with
a piece of filler material or foam tape to improve
the fit.
5/16"
Trim
Reveal
IMPORTANT NOTE: Maximum total panel weight:
® Fresh food door panel — 75 lbs.
® Freezer door panel — 53 lbs.
® Grille Panel — 18 lbs.
IMPORTANT NOTE - Dispenser Models
The refrigerator is supplied with two dispenser trims,
one for framed panels and one for overlay panels.
¢ If the panel is less than 0.250" thick a noticeable
gap may be created around the dispenser trim.
Foam tape may be applied on the door to improve
the fit.
¢ If the panel is more than 0.250" thick, the
dispenser trim cannot be secured to the door.
See Dispenser Trim Fit Example, page 9.
Dispenser Cutout
a
Grille Panel 8
. F
Dispenser
Cutout |
G C
Side-by-Side (in inches}
F Fresh Food
Panel | | Panel" 36" Models 33-7/8
42" Models 39-7/8
+ 48" Models 45-7/8
The framed panel must be 1/4" nominal thickness
to fit the dispenser trim.
g 68-3/8
9-1/2 68-3/8
9-1/2 68-3/8
14-9/16
14-9/16
18-9/16
18-9/16
24-9/16
26-9/16