Table of Contents
Advertisement
For the ultimate in convenience, install two refrigerators
side to side.
This trim kit includes 6 foam spacer pads to fill the gap
between the refrigerator side case trims. For a finished
appearance, a trim strip is provided to conceal the case
trim of the two refrigerators.
If you are installing into an enclosure, provide a 72" wide
opening. If you are installing where the sides of the
refrigerators will be exposed, allow additional width for
any side panels used.
• Apply foam spacer pads evenly to the side of one
refrigerator as shown.
• Slide second refrigerator into position.
• Check to be sure both refrigerators are level. If they
are not level, an obvious gap can be seen between
the side trims. Adjust leveling legs if needed. Slight
gaps will be concealed with the trim strip.
• Open both fresh food doors to access side trim.
• The U-shape trim will overlap the side case trim of
both refrigerators.
• Set the top case trim (see page 17) to installation
height.
• Hold trim strip against top end of case, at the point
where case overlaps to the bottom of case trim. See
illustration.
• Mark length with a pencil.
• Trim excess length.
• Starting at the top, press trim strip over case trims of
both refrigerators.
• Continue pressing about half way down. Slide open
freezer drawers and continue pressing trim until you
reach the bottom of the strip.
ZFC1 Trim Kit
Side to Side Installation
Case Trim
Foam
Spacer
Pads
U-Shape
Trim
39
Advertisement
Table of Contents
