Installing The Fork Protector; Removing The Lower Triple Clamp - Husqvarna TE 125 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.10

Installing the fork protector

12.11

Removing the lower triple clamp

Main work
–
Remove screws
–
Remove the screws on the right fork leg. Lift off the fork protector.
101327-10
x
Main work
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
101327-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
x
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
Main work
–
Remove screw
dlebar, and set it aside.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
L01624-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
L01623-10
on the left fork leg. Lift off the fork protector.
1
( p. 45)
x
x ( p. 75)
p. 84)
( p. 75)
x
( p. 44)
x
p. 49)
. Remove screw , take off the upper triple clamp with the han-
1 2
. Remove protective ring
3
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 83)
p. 82)
p. 43)
.
4
46
.
1