11
TUNING THE CHASSIS
11.14
Handlebar position
11.15
Adjusting the handlebar position
1
1
1
0 1
2
0 0 2
0 0 2
0
2
On the upper triple clamp, there are two holes a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar can
be mounted in the position that is most comfortable for the rider.
800116-10
x
–
Remove screws
to one side.
Info
Protect the motorcycle and its attachments against damage by covering
them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
–
Position the handlebar clamp. Mount and tighten screws
Guideline
Screw, handlebar clamp
Info
Ensure that the gap widths are even.
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar and lay it
1
. Remove the handlebar support.
2
M10
M8
apart.
A
from the center.
B
40 Nm
Loctite
®
243™
(29.5 lbf ft)
.
1
20 Nm (14.8 lbf ft)
42
.
2