12
SERVICE WORK ON THE CHASSIS
12.10
Installing the fork protector
12.11
Removing the lower triple clamp
Main work
–
Remove screws
–
Remove the screws on the right fork leg. Lift off the fork protector.
101327-10
Main work
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
101327-10
Finishing work
–
Install the fork legs.
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with the lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the front fender. (
Main work
–
Remove screw
–
Open cable holder
–
Open cable holder
–
Remove the upper triple clamp with the handlebar and set aside.
Info
Cover the components to protect them against damage.
Do not bend the cables and lines.
S00529-10
–
Remove O-ring
–
Take out the lower triple clamp with the steering stem.
–
Take out the upper steering head bearing.
L01623-11
on the left fork leg. Lift off the fork protector.
(
p. 45)
(
p. 76)
p. 86)
(
p. 76)
(
p. 44)
p. 50)
. Remove screw
.
in front of the left radiator and detach the clutch line.
in front of the right radiator and detach the wiring harness.
. Remove protective ring
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
p. 84)
p. 83)
p. 43)
.
46
.