Download Print this page

Installing The Rear Wheel; Checking The Tire Condition - Husqvarna TE 125 EU Owner's Manual

Husqvarna motorcycles 2014 owner's manual
Hide thumbs

Advertisement

14
WHEELS, TIRES
14.4

Installing the rear wheel

Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
14.5

Checking the tire condition

Info
Only mount tires approved and/or recommended by Husqvarna.
Other tires could have a negative effect on handling characteristics.
The type, condition, and air pressure of the tires all have an important impact on the handling characteristics of the motorcycle.
The tires mounted on the front and rear wheels must have a similar profile.
Worn tires have a negative effect on handling characteristics, especially on wet surfaces.
x
Main work
Check the wheel bearing for damage and wear.
»
If the wheel bearing is damaged or worn:
Change the wheel bearing.
Clean and grease shaft seal rings
Insert the spacers.
101848-11
Lift the rear wheel into the swingarm, position it, and insert wheel spindle
Put the chain on.
The brake linings are positioned.
B01791-10
Position chain adjuster
Make sure that chain adjusters
Check the chain tension. (
Tighten nut
Guideline
Nut, rear wheel spindle
Info
The wide adjustment range of the chain adjusters (32 mm (1.26 in)) enables
different secondary ratios with the same chain length.
Chain adjusters
Operate the foot brake lever repeatedly until the brake linings are in contact with the
brake disc and there is a pressure point.
B01792-10
Finishing work
Remove the motorcycle from the lift stand. (
x
and bearing surface
1
. Mount nut
3
4
are fitted correctly on adjusting screws
3
p. 58)
.
4
can be turned by 180°.
3
of the spacers.
A
but do not tighten it yet.
M20x1.5
80 Nm (59 lbf ft)
p. 43)
77
.
2
.
5

Hide quick links:

Advertisement

loading