Draining The Gear Oil; Refilling With Gear Oil - Husqvarna TE 125 EU Owner's Manual

18 SERVICE WORK ON THE ENGINE
18.3

Draining the gear oil

Warning
Danger of scalding Engine oil and gear oil get very hot when the motorcycle is ridden.
–
Wear appropriate protective clothing and safety gloves. In case of burns, rinse immediately with lukewarm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Only drain the gear oil while the engine is warm.
18.4

Refilling with gear oil

Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
x
Preparatory work
–
Park the motorcycle on a level surface.
–
Remove the engine guard. (
–
Place a suitable container under the engine.
Main work
(TE 125)
–
Remove the gear oil drain plug with magnet
–
Remove gear oil drain plug
–
Completely drain the gear oil.
–
Clean the gear oil drain plug thoroughly.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet
L01712-10
Guideline
Gear oil drain plug with magnet
–
Mount gear oil drain plug
Guideline
Gear oil drain plug
(TE 250/300)
–
Remove the gear oil drain plug with magnet
–
Completely drain the gear oil.
–
Clean the gear oil drain plug with the magnet thoroughly.
–
Clean the sealing area on the engine.
–
Mount the gear oil drain plug with magnet
Guideline
Gear oil drain plug with magnet
L01662-10
Finishing work
–
Install the engine guard. (
x
p. 65)
.
1
.
2
and the seal ring and tighten.
1
M12x1.5
with the seal ring and tighten.
2
M10x1
.
1
and the seal ring and tighten.
1
M12x1.5
p. 65)
97
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)
20 Nm
(14.8 lbf ft)