Installing The Lower Triple Clamp - Husqvarna TE 125 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.12

Installing the lower triple clamp

x
Main work
–
Clean the bearing and sealing elements, check for damage, and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
–
Check whether the top steering head seal
–
Slide on protective ring
B01632-10
–
Position the upper triple clamp with the steering.
–
Mount screw
–
Mount the clutch line with cable guide
L01625-10
–
Position the fork legs.
Info
The rebound damping is located in the right fork leg (red adjusting screw).
The compression damping is located in the left fork leg (white adjusting
screw).
Grooves are milled into the side of the upper end of the fork legs. The sec-
ond milled groove (from the top) must be flush with the top edge of the upper
triple clamp.
Position bleeder screws
L01628-10
–
Tighten screws
Guideline
Screw, bottom triple clamp
L01670-10
–
Tighten screw
Guideline
Screw, top steering head
L01626-10
p. 121)
and O-ring
2 3
but do not tighten yet.
4
5
toward the front.
6
.
7
.
4
is correctly positioned.
1
.
.
M8 15 Nm (11.1 lbf ft)
M20x1.5 12 Nm (8.9 lbf ft)
47