12
SERVICE WORK ON THE CHASSIS
12.48
Removing the engine guard
12.49
Installing the engine guard
–
Inject the liquid into the system until it escapes from hole
der without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container rim
–
Position the cover with the membrane. Mount and tighten the screws.
B01540-10
(TE 125)
–
Turn quick release
guard.
L01704-10
(TE 250/300)
–
Turn quick release
guard.
L01644-10
(TE 125)
–
Attach the engine guard on the frame at the rear and swing up at the front.
–
Turn quick release
L01704-10
(TE 250/300)
–
Turn quick release
–
Attach the engine guard on the frame at the rear and swing up at the front.
L01644-10
4 mm (0.16 in)
counterclockwise until it disengages. Remove the engine
1
counterclockwise until it disengages. Remove the engine
1
clockwise all the way.
1
clockwise all the way.
1
65
of the master cylin-
6