Adjusting The Play Of The Steering Head Bearing; Greasing The Steering Head Bearing; Removing The Front Fender - Husqvarna TE 125 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.14

Adjusting the play of the steering head bearing

12.15

Greasing the steering head bearing

12.16

Removing the front fender

» If detent positions are noticeable:
–
Adjust the play of the steering head bearing.
–
Check the steering head bearing and change if necessary.
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with the lift stand. (
Main work
–
Loosen screws
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
Guideline
L01629-10
Screw, top triple clamp
–
Mount and tighten screw
Guideline
Screw, top steering stem
Finishing work
–
Check the play of the steering head bearing. (
–
Remove the motorcycle from the lift stand. (
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Disconnect plug-in connectors
–
Remove screws
–
Take the brake line and wiring harness out of the brake line guide.
C00596-10
x
. Remove screw .
1 2
.
3
.
1
.
2
M8
( p. 46)
x
( p. 47)
x
of the turn signals.
1
.
2
( p. 49)
x
p. 43)
p. 43)
M20x1.5 12 Nm (8.9 lbf ft)
M8 17 Nm (12.5 lbf ft)
17 Nm Loctite
(12.5 lbf ft)
p. 48)
p. 43)
p. 82)
49
® 243™