Installing The Fork Protector; Removing The Lower Triple Clamp - Husqvarna TC 85 19/16 2020 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.8
11.9
50

Installing the fork protector

A00141-10

Removing the lower triple clamp

S03429-10
S03430-10
–
Position the fork protector on the right fork leg. Mount and
1
tighten screws .
Guideline
Remaining screws,
chassis
–
Position the fork protector on the left fork leg. Mount and
2
tighten screws .
Guideline
Remaining screws,
chassis
–
Position the brake line and clamp. Mount and tighten
3
screws .
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
–
Remove the fork legs.
–
Remove the start number plate. (
–
Remove front fender. (
–
Remove the handlebar cushion.
Main work
–
1
Pull fuel tank breather
–
2
Loosen screw . Remove nut
clamp with the handlebar in an upward direction, and hang it
to the side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
–
4
Remove protective ring
–
Take off the lower triple clamp with the steering stem in a
downward direction.
–
Remove the upper steering head bearing.
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 46)
( p. 88)
( p. 47)
p. 55)
p. 56)
out of the steering stem.
3
, pull off the upper triple
.