Changing The Main Fuse (Te 250/300); Removing The Headlight Mask With The Headlight - Husqvarna TE 125 EU Owner's Manual

15 ELECTRICAL SYSTEM
15.4

Changing the main fuse (TE 250/300)

Warning
Fire hazard The electrical system can be overloaded if the wrong fuses are used.
–
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
Info
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box lid.
15.5

Removing the headlight mask with the headlight

Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the air filter box lid. (
Main work
–
Remove protection caps
–
Remove the faulty main fuse
Info
A defective fuse can be identified by the burned-out fuse wire
A reserve fuse
–
Install a new main fuse.
Fuse (58011109110)
–
Check that the electrical equipment is functioning properly.
Tip
Insert the spare fuse so that it is available if needed.
–
Mount the protection caps.
–
Mount the starter relay onto the holder and lay the cable.
L01651-10
Finishing work
–
Install the air filter box lid. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
Main work
–
Open rubber bands
–
Tilt the headlight mask forward and detach at catch
–
Disconnect connector
–
Take off the headlight mask with headlight.
B01787-10
p. 52)
.
1
.
2
is located in the starter relay.
3
p. 52)
on the fork legs.
1
.
3
.
A
.
2
82