Removing The Main Silencer; Installing The Main Silencer; Changing The Glass Fiber Yarn Filling Of The Main Silencer - Husqvarna TE 125 EU Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.28

Removing the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
12.29

Installing the main silencer

12.30

Changing the glass fiber yarn filling of the main silencer

Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Info
Over time, the fibers of the glass fiber yarn filling escape and the damper "burns" out.
Not only is the noise level higher, the performance characteristic changes.
Preparatory work
–
Remove the right side cover. (
Main work
–
Remove screws
–
Pull the main silencer off of the manifold at rubber sleeve
L01633-10
Main work
–
Mount the main silencer with rubber sleeve
–
Mount and tighten screws
Guideline
Remaining screws, chassis
L01634-10
Finishing work
–
Install the right side cover. (
Preparatory work
–
Remove the right side cover. (
–
Remove the main silencer. (
p. 55)
.
1
1
.
2
M6
p. 55)
x
p. 55)
p. 54)
.
2
.
10 Nm (7.4 lbf ft)
54