Installing The Headlight Mask With The Headlight; Changing The Headlight Bulb - Husqvarna TE 125 EU Owner's Manual

15 ELECTRICAL SYSTEM
15.6

Installing the headlight mask with the headlight

15.7

Changing the headlight bulb

Note
Damage to reflector Reduced brightness.
–
Grease on the lamp will evaporate due to the heat and be deposited on the reflector. Clean the lamp and keep it free of grease
before mounting.
Main work
–
Plug in connector
–
Check that the lighting is functioning properly.
–
Attach headlight holder
B01787-11
–
Position rubber bands
The wiring harness and brake line
B01784-10
Finishing work
–
Check the headlight setting. (
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. (
Main work
–
Turn protection cap
and lift it off.
–
Pull bulb socket
L00269-10
–
Press headlight bulb
wise, and pull it out.
–
Insert the new headlight bulb.
Headlight (S2/socket BA20d) (
–
Insert the protection cap with the bulb socket into the reflector and turn it all the way
clockwise.
–
Insert the bulb socket of the parking light into the reflector.
100463-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
.
1
at catch and position the headlight mask.
2 3
around the fork legs and close them.
4
are routed in front of the headlight mask.
5
p. 84)
with the bulb socket beneath it all the way counterclockwise
1
of the parking light out of the reflector.
2
lightly into the bulb socket, turn it all the way counterclock-
3
p. 110)
p. 84)
p. 82)
p. 83)
83