System Configuration - Daikin E Series Service Manual

Installation Manual
Indoor Unit Installation Drawings
2.
Removing and installing indoor unit.
• Installation method
1) Using the
indoor unit, attach the
onto the indoor unit.
2) Attach the tabs on the bottom frame onto the
mounting plate. If the tabs are not hooked onto
A
the plate, remove the front grille to hook them.
(Check to see if the tabs are hooked securely.)
• Removal method
Push up the mark part on the bottom of the front
grille, discharge the tabs, and then remove the unit
while lifting it up.
Mounting plate
A
Screws
(Field supply: M4 × 25L)
Front panel
Air supply
D
filter
50mm or more
from walls
(on both sides)
Titanium apatite
C
photocatalytic
air-purifying filter
3
84
marks (3 locations) on top of the
mounting plate hooks
A
The mounting plate
A
should be installed on a
wall which can support the
weight of the indoor unit.
Supporting plate
Supporting plate
30mm or more
from ceiling
The securing tape is applied.
Be sure to remove it before
installation.
Air filter
Mounting
A
plate
Bottom
frame
Mark
(rear side)
Tab To remove the unit, push up the bottom of the bottom
frame with your fingers to free tabs.
(Mark parts (2 locations) on the bottom of the front grille.)
How to open the service lid
The service lid is
removable.
Opening the lid
1) Remove the screws
on the service lid.
2) Hold the knobs on the
Use when
service lid and pull
opening the
forward.
front panel and
securing.
Humidifying
hose
Install the
hose with a
downward
slope.
B Deodorizing filter
for streamer
Set the
batteries.
J
Screws
(Field supply: M3 × 20L)
SiBE04-624
Mounting
A
plate
2)
1)
If it is difficult to lay the humidifying
hose, cut it, lay it, and connect it
using the joint or elbow included
with the outdoor unit.
Do not install the trap to
the humidifying hose as
much as possible.
Cut thermal insulation pipe
to an appropriate length and
wrap it with tape, making
sure that no gap is left in the
insulation pipe's cut line.
Wrap the insulation
pipe with the finishing
tape from bottom to top.
Wireless
G
remote controller
H
Hook
Remote
controller holder
Before screwing the
remote controller
holder to the wall,
make sure that control
signals are properly
received by indoor unit.

System Configuration