Table For Special Modes - Daikin E Series Service Manual

Main Functions

2.26 Table for Special Modes

[CANCEL] button
transmission normal
[Indoor ON/OFF] button
transmission
abnormal
[indoor ON/OFF]
button
[CLOCK] button
A. Diagnosis mode is improved to enable one-touch indication by applying two-way
B. Forced operation mode is the same as the conventional one. (But buzzer beeps, timer and
C. In indoor unit demonstration mode, the color of multi monitor changes regularly and the
D. In humidifying demonstration mode, the color of the multi-colored indicator changes
E. Trial operation mode is improved in such a way that the conventional 3 buttons to be
56
Operation of indoor unit ON/OFF button and buttons of remote controller
To enter a specific mode, press one of the buttons below for more than 5 sec.
A. Diagnosis mode
B. Forced operation mode
C.
Indoor unit
demonstration
mode
[ON/OFF]
button
E. Trial operation mode
Mode selection
view
F. Humidifying hose length
setting mode
Select by
(forward/back)
button, and press
G. Forced humidifying drying mode
the "CLOCK"
button.
H. Humidifying air flow rate
fine adjusting mode
communication.
multi-monitor illuminate)
sequence of events (front panel open → flaps swing → front panel close) repeats.
It takes about 10 minutes for 1 period.
regularly.
Select "URURU" HUMIDIFYING or HUMID HEATING for demonstration.
(This mode can be used for demonstration of humidification operation at shops.)
pressed simultaneously are integrated into one button.
The time to start compressor can be set by "
later.
Select the desired operation mode to start operation.
[CANCEL] button or leave it
for 60 sec.
[ON/OFF] button or leave it
for 15 min.
transmission
abnormal
[indoor ON/OFF]
button
Stop
transmission
normal
D.Humidifying
demonstration mode
[indoor ON/OFF]
button
[ON/OFF] button or leave it for 30 min.
[CLOCK] button or leave it for 30 min.
[CLOCK] button or leave it for 60 sec.
(forward)" button by 0 min., 1 min. or 3 min.
Power reset
Power reset
[ON/OFF] button
*Hose length
setting
[CLOCK] button
or leave it for
60 sec.
Function and Control
SiBE04-624
(R6029)