Preparation Before Operation - Daikin E Series Service Manual

Instruction
3.3

Preparation before Operation

Preparation Before Operation

To set the batteries
1. Press with a finger and slide the cover to take it off.
2. Set two dry batteries (AAA).
3. Set the cover as before.
•
Characters on the display will blink. Set the present time. (page 6.)
How to use
•
To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block
signals between the unit and the remote controller, such as a curtain, the unit will not operate.
•
The maximum distance for communication is about 7m.
•
Do not drop the remote controller. Do not get it wet.
(Damage to LCD may occur.)
To fix the remote controller holder on the wall
1. Choose a place from where the signals reach the unit.
2. Fix the remote controller holder to a wall or pillar using the
included screws.
3. Hook the holes on back of the remote controller to the protrud-
ing tabs on the remote controller holder.
Attach the Titanium apatite photocatalytic
air-purifying filter, deodorizing filter for streamer,
and air supply filter
Turn on the power breaker
•
Turning on the power breaker will cause the front panel and horizontal louver to open once
and then close again. (This is a normal procedure.)
CAUTION
•
During operation (i.e. when the panel is open or being opened or closed), do not touch the panel
with your hands.
ATTENTION
•
Wrap the terminals with tape to insulate them before discarding batteries. Mixing with other metals or batteries may cause heat, explosion or fire.
PRECAUTION
About batteries
•
The included batteries are provided to be used at first. Depending on when the air conditioner was manufactured, these batterie s may run
out in less than a year.
•
We recommend replacing once a year, although if the remote controller display begins to fade or if reception deteriorates, please replace
with new alkaline batteries.
•
When replacing the batteries, use batteries of the same type, and replace the two old batteries together.
•
Batteries close to their expiration dates will have to be replaced sooner.
•
To prevent breakage or injury due to leaking or explosion, remove the batteries if the unit is not used for a long period of time.
About remote controller
•
Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as inverter-type lamps) is in the room. Consult
the shop if that is the case.
•
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult the shop.
•
Direct sunlight on the transmitter/receiver may cause the unit to work harder.
5
110
(page 20, 23.)
SiBE04-624
Position + and
– correctly!
2
3
1
Remote
controller
holder
Receiver
System Configuration