Mold Shock Operation - Daikin E Series Service Manual

Main Functions

2.18 MOLD SHOCK Operation

The room is kept clean by removing excessive moisture by rapidly lowering the humidity in the
room for 1 hour, and keeping operation for 2 hours (total 3 hours).
Operation It is not self-starting operation.
∗ Refer to the operation manual for details.
Features
Method to prevent the generation of mold by suddenly drying the humid environment. It is
generally said that the growth of mold can be prevented by lowering the humidity to half and
continuing the operation for 3 hours.
Mold before mold shock operation
The test was conducted at DAIKIN's lab with use of the mold
sensor of Environmental Biological Research Institute.
Reheating dehumidifying
room temperature setting
<Note> The room temperature becomes about 5˚C lower than the temperature at the start of operation.
44
Dry shock method (Mold Shock Operation)
Time chart
Operation runs about for 3 hours in rotal while charging colors of the multi-colored
indicator lamp.
Reheating dehumidifying which dehumidifies continuously.
ON
Operation
OFF
Indoor Unit Fan
Room Temperature
Air flow direction
Reheating dehumidifying
primary setting.
Compressor
MOLD SHOCK Opeation
(Hold down for 2 seconds.)
Without mold shock operation
Fewer molds grow as compared with
in the case without Mold Shock Operation.
Approx. 3 hours
<Air flow rate in reheating dehumidifying>
<Angle in comfort air flow mode>
SiBE04-624
(R5975)
With mold shock operation
(R5107)
Continuous operation in
max. frequency
Function and Control
(R5108)