Set Up - Daikin E Series Service Manual

SiBE04-624

3.11 SET UP

SET UP

Sets the unit operation and remote controller display according to your preference.
1. Hold "
•
The setup mode will be activated.
2. The item will change every time "
3. The settings will change every time "
•
Direct the remote controller toward the main unit to make settings.
Item
CHILD PROOF LOCK
ON/OFF
MOLD PROOF
ON/OFF
MONITOR BRIGHTNESS
BEEP volume
CONTRAST Setting
Setting complete
NOTE
Note on CHILD PROOF LOCK
•
Selecting "ON" while CHILD PROOF LOCK setting and then pressing "
PROOF LOCK to be enabled and the display to show "
•
The button operations other than "
•
To cancel the CHILD PROOF LOCK, set to "OFF" following the above steps from 1 to 3.
System Configuration
for about 2 seconds.
"
" is pressed respectively.
Setting
•
Restricts the remote controller operations
OFF ON
to avoid misuse by children. (See NOTE.)
•
If the unit is set to "MOLD PROOF ON", it
may automatically enter MOLD PROOF
operation mode after operating in DRYING,
OFF ON DRY COOLING or COOLING operation
mode, depending on the amount of time it
had been operating. This is to dry out the
interior of the air conditioner. (page 15.)
• Changes the brightness of the indoor unit
HIGH LOW OFF
display.
•
LOW HIGH OFF Sets the receiving tone volume.
• Sets the grayscale for the remote controller
LCD.
1 6 16
• Selectable from contrast 1 to 16.
: The display on the remote control goes back to normal if no setting is
made for 10 seconds.
" are disabled in CHILD PROOF LOCK mode.
" is pressed.
is default.
Description
1, 2
" or making no setting for 10 seconds will cause the CHILD
".
Instruction
3
14
119