Mold Shock Operation / Information Display - Daikin E Series Service Manual

SiBE04-624

3.13 MOLD SHOCK Operation / INFORMATION DISPLAY

MOLD SHOCK OUT Operation
This mode dehumidifies the air in the room and prevents mold growth.
Continuous drying operation lowers the room humidity rapidly.
1. Hold "
•
The front panel and horizontal louver will open.
•
The MOLD SHOCK OUT operation runs for about 3 hours, changing the color of
the multi-colored indicator lamp on the unit.
<Color of multi-colored indicator lamp>
•
Blinks in order during the MOLD SHOCK OUT operation.
If you want to stop MOLD SHOCK OUT opera-
tion during operation
2. Hold "
•
The front panel and horizontal louver will close.
•
The multi-colored indicator of the unit will go off.
NOTE
Note on MOLD SHOCK OUT operation
•
The mode may not be used depending on the outdoor temperature.
<Operating range> Outdoor temperature of from 12 to 40°C
•
Temperature and humidity may not satisfy your preference during MOLD SHOCK
OUT operation. Run this operation mode while no one is in the room.
It is generally said that mold growth can be reduced when the humidity is below 60%.
INFORMATION DISPLAY
Displays the room temperature and humidity and outdoor temperature.
1. Press "
•
After pressing "
Set temperature
The display changes every time "
NOTE
Note on INFORMATION DISPLAY
•
The signal from the air conditioner is not being received properly if "Reception
Failed" is displayed when you press "
the air conditioner.
•
During operation, the outdoor temperature may sometimes be displayed higher
than it actually is in COOLING or "SARARA" DRYING mode or lower in HEATING
mode (especially if frost has accumulated on the outdoor unit), due to the effects of
the air blown from the outdoor unit or the temperature of the heat exchanger.
•
The lowest indoor and outdoor temperature which can be displayed is -9°C. This
will be displayed even if the actual temperature is lower. The highest temperature is
39°C. This will be displayed even if the actual temperature is higher.
•
The indoor and outdoor temperatures and the humidity which are displayed are
those near the sensors attached to the main air conditioner unit.
•
The displayed temperature and humidity should only be taken as approximations,
as they may be affected if there are objects around the sensors or due to direct sun-
light, depending on where the air conditioner is installed.
System Configuration
" for about 2 seconds while the unit is not running.
The MOLD SHOCK OUT operation will start.
The display will return to normal.
Light
Blue
blue
" (again) for about 2 seconds.
".
", point the remote controller at the air conditioner unit for 2 seconds.
Indoor temperature Outdoor
Indoor humidity temperature
". Repeat, aiming the remote controller at
White
Return to
normal
display
" is pressed.
Instruction
< >
MOLD SHOCK OUT
< >
INFORMATION DISPLAY
1, 2
1
16
121