Displaying Summary
Trunk Information
Displaying and
Changing IP-related
Information
Specifying IP and SLIP
Information
You can display summary trunk information about all trunks supported by
the stack using the
To display summary trunk information:
1 At the Top-level menu, enter:
feature trunk summary
2 The summary trunk information is displayed as shown in the example
below.
Unit 1
Trunk 1
Unit 1
Trunk 2
Unit 2
Trunk 1
Unit 2
Trunk 2
Select menu option:
You can display and change IP-related information for the current Switch
unit in the stack using the commands on the IP menu. These commands
allow you to:
Specify the IP and SLIP information for the Switch
Display the IP information for the Switch
Specify whether the Switch uses BOOTP
Ping other devices on your network
To display and change IP-related information for another Switch unit in
the stack, you need to select that unit using the
more information, see
Interface"
on
page
You can specify IP and SLIP information for the current Switch unit in the
stack using the
define
To carry out this command for the first time after installing your switch,
you need to connect a terminal or terminal emulator to the console port
using a null modem cable. See
Management"on
page 36
console port.
Displaying and Changing IP-related Information
command on the Trunk menu.
summary
In Use
No
No
No
No
"Moving the Focus of the Command Line
141.
command on the IP/Interface menu.
"Setting Up Command Line Interface
for more information about connecting to the
133
command. For
unit