Specifying Contact Details; Configuring The Stack - 3Com SuperStack II Manual

Specifying Contact
Details
Configuring the
Stack
You can specify the details of a person to contact about the stack using
the Contact page.
To access the Contact page:
1 Click the Management Settings icon on the side-bar.
2 Click the Contact hotlink. The Contact page is displayed as shown in
Figure 17.
Figure 17 The Contact page
You can configure the stack using the Configuration pages. These pages
allow you to:
Configure the Switch Database of the stack
Configure the advanced settings of the stack
Set up resilient links for the stack
Set up port trunks for the stack
Configure VLANs for the stack
Set up roving analysis ports for the stack
Reset the Switch units in the stack
Initialize the Switch units in the stack
Upgrade the management software of the Switch units in the stack
If an existing stack with STAP enabled is powered-up with a new unit that
has STAP disabled, the setting of the new unit may override the whole
stack. A similar issue may also be encountered with the broadcast storm
control setting. The recommended procedure to overcome this problem is
to either (i) configure the new unit appropriately before adding it to the
stack or (ii) reconfigure the stack appropriately immediately after power-up.

Configuring the Stack

71