Displaying Switch Administration Details - 3Com SuperStack II Manual

Displaying Switch
Administration
Details
You can display the administration details for the current Switch unit in
the stack using the
display
information may be useful for your technical support representative if you
have a problem.
To display the information:
From the Top-level menu, enter:
system display
The administration details are displayed.
An example of the details is shown below. Some fields are only displayed
after a software upgrade failure and these provide information about the
software upgrade.
3Com SuperStack II
System Name:
Location:
Contact:
Time since reset:
Operational Version:
Hardware Version
Boot Version:
MAC Address:
Product No.
Serial Number
TFTP Server Address
Filename
Last software upgrade
The following read-only fields are displayed:
System Name
Displays the descriptive name, or system name, for the unit. For
information about assigning a new name, see
Administration Details"
Location
Displays the physical location of the unit. For information about assigning
a new location, see "Specifying Stack Administration Details"
page 142.
Contact
Displays the details of a person to contact about the stack. For
Displaying and Changing Stack Information
command on the System menu. This
Development
Wiring Closet, Floor 1
System Administrator
2 days, 3 hours, 10 minutes
2.20
1
1.00
08:00:00:00:11:11
3C33000
7ZNR001111
161.71.120.152
s2s02_50.bin
TFTP Access Violation
on page 142.
"Specifying Stack
on
143