Default Settings - 3Com SuperStack II Manual

Default Settings

Table 4 shows the default settings of units in the Switch 1100/3300 and
610/630 family. If you initialize one of these Switch units, it is returned to
these defaults.
Table 4 Default Settings
Switch 1100/610 Family
Port Status Enabled
Port Speed 10BASE-T/
100BASE-TX ports are
auto-negotiated.
Forwarding Intelligent
Mode
Duplex Mode All fixed 10BASE-T and
10BASE-T/100BASE-TX ports are
auto-negotiated.
Flow Control Enabled in half duplex,
auto-negotiated in full duplex
PACE Disabled
Security Disabled
Broadcast Enabled
Storm Control
Enabled
BOOTP
Virtual LANs All ports belong to the
(VLANs) untagged Default VLAN
(VLAN 1) only; 802.1Q learning
is disabled
FastIP Disabled
Multicast 802.1p and IGMP filtering are
Filtering both disabled
Spanning Tree Disabled
Protocol
RMON Alarm Enabled:
(broadcast High threshold: 2976 broadcast
bandwidth frames per second — Notify and
filter
used)
Low threshold: 1488 broadcast
frames per second — Notify and
unfilter
Default Settings
Switch 3300/630 Family
Enabled
10BASE-T/100BASE-TX ports are
auto-negotiated; 1000BASE-T
and 1000BASE-SX ports are
permanently fixed at 1000Mbps
Store-and-forward
All fixed 10BASE-T/100BASE-TX
ports are auto-negotiated; all
fixed 100BASE-FX ports are half
duplex; all 1000BASE-T and
!000BASE-SX ports are
permanently set to full duplex.
Enabled in half duplex,
auto-negotiated in full duplex
Disabled
Disabled
Enabled
Enabled
All ports belong to the
untagged Default VLAN
(VLAN 1) only; 802.1Q learning
is disabled
Disabled
802.1p and IGMP filtering are
both disabled
Disabled
Enabled:
High threshold: 2976 broadcast
frames per second — Notify and
filter
Low threshold: 1488 broadcast
frames per second — Notify and
unfilter
29