3Com SuperStack II Manual page 102

102 C 4: W
HAPTER ORKING
W C L I
ITH THE OMMAND INE
Table 8 Command line interface commands
Command
bridge port vltMode
bridge stpForwardDelay
bridge stpHelloTime
bridge stpMaxAge
bridge stpPriority
bridge stpState
bridge vlan addPort
bridge vlan create
bridge vlan delete
bridge vlan detail
bridge vlan modify
bridge vlan removePort
bridge vlan summary
ethernet autoNegotiation Enables and disables auto-negotiation for ports
ethernet flowControl
ethernet portMode
ethernet portState
ethernet statistics
ethernet summary
feature analyzer add
NTERFACE
What does it do?
Enables or disables VLT tagging on a port on
the current Switch unit.
Sets the bridge Forward Delay spanning tree
parameter.
Sets the bridge Hello Timer spanning tree
parameter.
Sets the bridge Maximum Age spanning tree
parameter.
Sets the spanning tree bridge priority.
Enables and disables the spanning tree
protocol.
Adds a single port to a VLAN. Also allows you
to add all ports on the current Switch unit to
the selected VLAN.
Creates a VLAN.
Deletes a single VLAN.
Displays detailed information about a VLAN,
such as port membership and statistics.
Modifies the VLAN name for a specified VLAN
ID.
Removes a single port from a VLAN.
Displays summary information about a VLAN,
specifically the port membership.
on the current Switch unit in the stack.
Enables and disables IEEE 802.3x flow control
for ports on the current Switch unit in the stack.
Specifies the speed and duplex mode of ports
on the current Switch unit in the stack
Enables and disables ports on the current
Switch unit in the stack.
Displays statistical information about ports on
the current Switch unit in the stack.
Displays summary information about the ports
on the current Switch unit in the stack.
Configures the roving analysis port (that is the
port that the network analyzer will be
connected to) on any unit in the stack.