3Com SuperStack II Manual page 104

104 C 4: W
HAPTER ORKING
W C L I
ITH THE OMMAND INE
Table 8 Command line interface commands
Command
snmp get
snmp next
snmp set
snmp trap define
snmp trap display
snmp trap modify
snmp trap remove
system display
system information
system initialize
system inventory
system module define
system module display
system module mode
system password
system remoteAccess
system reset
system security access
display
system security access
modify
system security user
define
system security user
display
NTERFACE
What does it do?
Performs an SNMP GET command, that allows
you to retrieve values of SNMP objects from the
stack.
Performs an SNMP GETNEXT command, that
allows you to specify an SNMP object and then
retrieve the next few SNMP objects from the
stack.
Performs an SNMP SET command, that allows
you to modify the value of an SNMP object in
the stack.
Specifies the trap destination details for the
stack.
Displays the details of the current trap
destinations for the stack.
Modifies trap destination details for the stack.
Removes trap destination details from the stack.
Displays administration details for the current
Switch unit in the stack.
Specifies administration details for the stack.
Initializes the Switch units in the stack.
Displays a list of the Switch units in the stack.
Sets the IP configuration for a Switch Layer 3 or
Switch ATM module.
Displays the module configuration details.
Allows you to enable or disable an intelligent
module.
Specifies the password for the current user.
Enables and disables all forms of remote access
to the stack.
Resets the Switch units in the stack.
Displays the access rights for all access levels in
the stack.
Modifies the access rights for the access levels
in the stack.
Specifies the user details for the stack.
Displays the user details for the stack.