Stopping Data Monitoring; Enabling And Disabling Broadcast Storm Control - 3Com SuperStack II Manual

Stopping Data
Monitoring
Enabling and
Disabling Broadcast
Storm Control
You can stop data monitoring by the roving analysis port and remove the
monitor port from the roving analysis set up by using the
on the Analyzer menu.
To stop data monitoring by the roving analysis port and remove the
monitor port:
At the Top-level menu, enter:
feature analyzer stop
You can enable or disable broadcast storm control for the Switch unit or
stack using the
broadcastStormControl
menu.
To enable or disable broadcast storm control for the Switch:
1 At the Top-level menu, enter:
feature broadcastStormControl
The following prompt is displayed:
Enter new value (disable, enable) [disable]:
2 Enter or
enable disable
If you enter
enable
Enter rising threshold in pps (0-200000) [2976]:
3 Enter the value for the rising threshold in packets per second.
The following prompt is displayed:
Enter falling threshold in pps (0-200000) [1488]:
4 Enter the value for the falling threshold in packets per second.
The following prompt is displayed:
Enter time period in seconds (10-60) [30]:
5 Enter the time period value in the range of 10 to 60 seconds.
Displaying and Changing System Feature Information
.
, the following prompt is displayed:
command
stop
command on the Feature
129