Adjustments; Specifications; Torque - Chrysler Concorde 2004 Service Manual

LH
EXHAUST SYSTEM (Continued)
1 - SUPPORTS
2 - MUFFLER
component to maintain position and proper clearance
with underbody parts.
(6) Tighten band clamps to 61 N·m (45 ft. lbs.).
(7) Lower the vehicle.
(8) Start the engine and inspect for exhaust leaks.
Repair exhaust leaks as necessary.
(9) Check the exhaust system for contact with the
body panels. Make the necessary adjustments, if
needed.

ADJUSTMENTS

A misaligned exhaust system is usually indicated
by a vibration, rattling noise, or binding of exhaust
system components. These noises are sometimes hard
to distinguish from other chassis noises. Inspect
exhaust system for broken or loose clamps, heat
shields, isolators, and brackets. Replace or tighten as
necessary. It is important that exhaust system clear-
ances and alignment be maintained.
Perform the following procedures to align the
exhaust system:
(1) Loosen clamps and support brackets.
(2) Align the exhaust system starting at the front,
working rearward.
Fig. 4 Exhaust System Supports
3 - ISOLATORS
(3) Tighten all clamps and brackets once align-
ment and clearances are achieved.

SPECIFICATIONS

TORQUE

Band Clamp
Catalytic Converter Pipe to Support
Bracket - Nut
V-Band Clamp - Exhaust Manifold to
Catalytic Converter
Exhaust Support to Body Bracket -
Fasteners
Exhaust Support Bracket to
Transmission - Fasteners
Right Rear Resonator (300M
Special) - Nuts
EXHAUST SYSTEM 11 - 5
DESCRIPTION N·m Ft. In.
Lbs. Lbs.
61 45 —
47 35 —
11 — 100
25 — 215
47 35 —
28 — 250