Remoteview Components; Installing The Remoteview Service Board S2 Lp - Fujitsu PRIMERGY RX600 S3 Options Manual

9

RemoteView components

V
ATTENTION!
Make sure you observe the safety notes in the
on page 13ff.
The RemoteView Service Board S2 LP (RSB S2 LP) is a low-profile PCI board
including a completely independent system, i.e. it has a separate operating
system with a Web server and SNMP agent and can be driven by an external
power supply.
The RSB S2 LP is connected to the system board via an IPMB cable. It permits
remote diagnosis for system analysis, remote system configuration and remote
restart even in the event of operating system failure or hardware faults.
9.1 Installing the RemoteView Service Board
S2 LP
Ê Open the server as described in
Ê Remove the slot cover of a (non-hot-plug) PCI slot on the back side of the
server.
I
The RSB S2 LP should preferably be installed in the (non-hot-plug)
PCI slot 7.
Keep the slot cover.
If you remove the board, you must reinstall the slot cover to comply
with EMC regulations (regulations on electromagnetic compatibility)
and to satisfy cooling requirements and fire protection measures.
U41640-J-Z156-2-76
chapter "Preparation" on page
Options Guide RX600 S3
chapter "Important notes"
23f.
57