Starting Up Hot-Plug Pci Slots - Fujitsu PRIMERGY TX300 Operating Manual

Preparation for Use and Operation

Starting up Hot-Plug PCI Slots

5.4 Starting up Hot-Plug PCI Slots
In addition to standard slots, the server also has hot-plug PCI slots. These hot-
plug PCI slots allow boards to be installed and removed during operation
assuming the operating system supports this functionality.
Every hot-plug PCI slot is assigned two indicators that signal the current status
of the slot. The indicators are visible on card guide on the inside of the server
((b) and (c) on figure 39 on page 95).
The possible indicator modes and their meaning are explained in table 3 on
page 62 and table 4 on page 63.
If it is attempted to remove the relevant board despite the illuminated green
indicator, the slot is automatically powered off to protect the board and the
system from any damage.
The hot-plug functionality is supported by the currently available Windows
operating systems.
The PCI hot-plug software (PCI Card HotReplace) is located on the ServerStart
CD supplied or is installed with the ServerView agents. You will find additional
information on installation and operation in the file "README for the PCI Hot
Plug Software V3.0" on the ServerStart CD.
PCI components may only be installed and removed by personnel with the
appropriate technical training.
65
A26361-K881-Z102-4-7619