Qos Shaper Configuration; Figure 33: Static - Allied Telesis AT-AR256E User Manual

42
Static Ingress
The Ingress - Static page enables you to configure a static CoS for all packets received on a WAN or LAN
interface.
To configure Ingress Static:
1. Select Advanced menu.
2. Select QoS > Ingress.
3. Select the quickstart interface.
4. Select Static.
5. At the ETHERNET Interface. You are configuring QoS on this interface only. Any WAN/LAN interface
that is not configured has the default Untrusted mode.
6. Select CoS1 in Class of Service. All incoming traffic from the ETHERNET interface receives CoS1,
the highest priority.
7. Click Apply to temporarily activate the settings.
8. To make changes permanent, click Save Settings.

QoS Shaper Configuration

The QoS Shaper Configuration page is accessed by selecting Shaper on the Advanced page. Three shaper
algorithms are supported:
• HTB
• Low Latency Queue Discipline
• PRIOWRR
All manuals and user guides at all-guides.com
AT-AR256E v3 - 4 Ports ADSL2/2+ Router - User Manual

Figure 33: Static