Mj/Ps Shield Unit (Mj Pcb* And Power Supply Pcb) - Brother DCP375CW Service Manual

6.1.10 MJ/PS Shield Unit (MJ PCB* and Power Supply PCB)

(1) If the main PCB shield frame has not been removed, disconnect the power supply harness,
main-MJ (LINE) harness* and main-MJ (EXT) harness* from the main PCB, then remove
screw "d" (shown on the previous page) from the main PCB shield frame.
(2) Remove the two screws ("h" and "i") as shown below.
(3) Release the harnesses from the cable guides provided on the lower cover and remove the
MJ/PS shield unit from underside of the lower cover.
Main-MJ (LINE) harness*
Main-MJ (EXT) harness*
"i"
"h"
6-50
Lower cover
MJ/PS shield unit
U-shaped cutout
Power supply harness
"h": Screw, pan (s/p washer) M3x8
"i": Taptite, cup S M3x6
* For MFC only
(6_49)
Confidential