Installing The Maintenance Usb Printer Driver - Brother DCP375CW Service Manual

7.1.2 Installing the Maintenance USB Printer Driver

If you want to change the programs stored in the flash ROM on the main PCB or after you
replace the main PCB, load the desired programs to the flash ROM.
Loading requires a PC/AT-compatible computer running Windows 2000 or later.
Caution: During loading, never turn off your PC or the machine, unplug the USB interface
cable, interrupt loading, or load invalid data. If you do so, loading will fail, causing the PCB to
be unusable. You will have to replace the main PCB and load programs to a new PCB.
Preparation
You need the Brother Maintenance USB Printer driver and filedg32.exe (provided by Brother
Industries). Save them in an arbitrary folder in your PC.
Installing the Brother Maintenance USB Printer driver
To identify machines connected via USB direct interface, the PC requires the corresponding
driver for the virtual USB device. If you connect any number of machines to your PC, the same
number of virtual USB devices will be automatically configured on your PC. To prevent many
virtual USB devices from being configured, use the unique driver installation procedure
described below that enables your PC to identify terminals via one single virtual USB device.
NOTES: • Once this installation procedure is carried out for a PC, no more driver/software
installation will be required for that PC to identify machines. If the Brother
Maintenance USB Printer driver has been already installed to your PC according to
this procedure, skip this section.
• Before proceeding to the procedure given below, make sure that the Brother
Maintenance USB Printer driver is stored in your PC.
(1) Check that the power switch of the machine is turned off. Disconnect the USB cable that
connects the machine with your PC.
(2) Turn on your PC.
(3) Turn on the power switch of the machine.
(4) Switch the machine to the maintenance mode using the steps below. (Refer to
Models without touch panel
Press the Menu and Black Start (Mono Start) keys in this order. Next press the
four times.
Models with touch panel
Press the Menu key on the touch panel and the Black Start (Mono Start) key on the
control panel. Next press the Scan key four times.
TIP: When the touch panel is inoperable, simultaneously press the Scan and Copy keys on
the control panel, instead of the Menu key, and press the Black Start (Mono Start) key.
Next press the Scan key four times.
TIP: Models equipped with a numerical keypad on the control panel can enter the
maintenance mode in the same way as conventional models; that is, by pressing the Menu,
*, 2, 8, 6 and 4 keys in this sequence.
The machine
"
the maintenance mode, a mode in which the machine is ready to accept entry from the keys.
beeps for approx.
" on the LCD, indicating that it is placed in the initial stage of
7-3
one second (MFC
Chapter 9.)
key
only) and displays
Confidential