Brother DCP375CW Service Manual page 259

Head joint and ink refill ASSY
(12) Pull out the joint leaf spring to the right to release the head joint.
(13) Pull the head joint up and off the head/carriage unit.
Remove the head joint rubber (that is a part of the head/carriage unit but may come off with
the head joint) and put it on a clean vinyl sheet while taking care not to contaminate it.
Note: Wipe off the ink remaining on the section where the head joint was mounted with a
clean, lint-free cloth.
Note: Wrap the head joint in a clean, lint-free cloth and keep it higher than the ink supply
tubes to prevent ink remaining in the ink supply tubes from leaking and the machine from
getting stained with leaked ink.
Ink supply tubes
Head/carriage unit
Assembling Note: Before setting the head joint, make sure that the head joint rubber is set
on the head/carriage unit as shown above. Then secure the head joint to the head/carriage
unit with the joint leaf spring.
Head joint
Head/carriage unit
6-66
Joint leaf spring
Head joint rubber
Joint leaf spring
Head joint
(6_60_1)
Confidential