Brother DCP375CW Service Manual page 446

EEPROM Customizing Codes
This function allows you to customize the EEPROM according to language, function settings,
and firmware switch settings.
Refer to the "EEPROM Customizing Codes List" on the following pages.
Operating Procedure
(1) Switch the machine to the maintenance mode using the steps below. (Refer to
Models without touch panel
Press the Menu and Black Start (Mono Start) keys in this order. Next press the
four times.
Models with touch panel
Press the Menu key on the touch panel and the Black Start (Mono Start) key on the
control panel. Next press the Scan key four times.
TIP: When the touch panel is inoperable, simultaneously press the Scan and Copy keys on
the control panel, instead of the Menu key, and press the Black Start (Mono Start) key.
Next press the Scan key four times.
TIP: Models equipped with a numerical keypad on the control panel can enter the
maintenance mode in the same way as conventional models; that is, by pressing the Menu,
*, 2, 8, 6 and 4 keys in this sequence.
The machine
"
the maintenance mode, a mode in which the machine is ready to accept entry from the keys.
(2) Press the 7 and 4 keys in this order in the initial stage of the maintenance mode.
For models without numerical keypad, to enter numerical codes, press the
times to display the numerical code to be entered and then press the OK key. Repeat this
operation for each numerical code.
The "SELECT 74?" appears on the LCD.
(3) Press the Black Start (Mono Start) key, and the current customizing code appears.
(4) Enter the desired customizing code.
For models without numerical keypad, to enter numerical codes, press the
times to display the numerical code to be entered and then press the OK key. Repeat this
operation for each numerical code.
If the customizing code contains letters "A" through "F," on models with a numerical
keypad on the control panel, press the 1 through 6 keys while holding down the # key,
respectively. On models with a touch panel, press the "A" through "F" keys on the software
keypad.
The newly entered code appears.
NOTE: If a wrong 4-digit code is entered, the machine will malfunction.
(5) Press the Black Start (Mono Start) key.
The machine saves the setting and returns to the initial stage of the maintenance mode.
If you press the Stop/Exit key or no keys are pressed for one minute in the above
procedure, the machine stops the procedure and returns to the initial stage of the
maintenance mode.
beeps for approx.
" on the LCD, indicating that it is placed in the initial stage of
App. 3-1
one second (MFC
Chapter 9.)
key
only) and displays
/ key several
/ key several
Confidential