Brother DCP375CW Service Manual page 201

(3) Disconnect the CIS flat cable from the main PCB, pull it to the rear through the flat core,
and then release it from the cable guides. Unlatch the flat core and take it out of the upper
cover.
NOTE: After disconnecting the flat cable(s), check that each cable is not damaged at its
end or short-circuited. When connecting the flat cable(s), do not insert it at an angle. After
insertion, check again that it is not at an angle.
(4) Models with ADF: Release the grounding wire by removing the screw.
(5) Disconnect the following harness(es) from the main PCB.
- CIS motor harness (4-wire)
- ADF motor harness (4-wire)
- Document front sensor harness (3-wire)
- Document rear sensor harness (3-wire)
1
Grounding wire*
Document
front sensor
1
harness*
CIS motor harness
*1
*1
*1
Scanner cover
(Scanner unit)
Taptite, cup S
1
M3x6*
6-8
*1 For models with ADF
CIS flat cable
Flat core
Lower cover
Latch
Document rear sensor harness*
1
ADF motor harness*
Upper cover
1
(6_05_mini9e)
Confidential