Margin Adjustment In Borderless Printing (Function Code 66) (User-Accessible) - Brother DCP375CW Service Manual

9.4.21 Margin Adjustment in Borderless Printing (Function code 66)
(User-accessible)
Function
This function allows you to adjust the left, right and bottom margins for borderless printing.
You print out a margin check pattern, measure each margin, and enter the correction values.
Operating Procedure
(1) Switch on your PC.
(2) Place the machine in the maintenance mode (see
paper tray to print margin check patterns.
(3) Connect the machine to your PC using a USB cable.
(4) On the PC, run "filedg32.exe" in the folder created in
The Filedrgs window appears as shown below.
(5) Drag and drop the "media_bottomadj_a4.prn" onto the Brother Maintenance USB Printer
driver icon in the Filedrgs window shown above.
The machine displays the "RECEIVING DATA" on the LCD and prints out the "MEDIA
& BOTTOM CHECK" pattern (see
the left, right, and bottom margins.
Left and right margin adjustment
(6) Measure the left and right margins on the printed pattern.
The upper row is printed in 600 dpi, and the lower row, in 1200 dpi.
(Example) 600 dpi
If both of the left and right margins are within the range from 0.9 to 1.1 mm, no adjustment
is required. If not, go to step (7).
Left: 0.8 mm, Right: 1.1 mm
1200 dpi Left: 0.9 mm, Right: 1.2 mm
Section 9.1) and set letter-size paper in the
Section
page 9-51 for a sample printout). This is for checking
9-48
7.1.1.
Confidential