Brother DCP375CW Service Manual page 232

(4) Open the ink cartridge cover.
(5) Remove the seven screws (six "a" and one "b" screws) from the upper cover.
(6) Release the two bosses provided on the bottom rear of the upper cover from the lower
cover using the tip of a flat screwdriver from the bottom, and then lift the upper cover up
and off the lower cover.
NOTE: When lifting up the upper cover, do not put your hands in the opening above the
platen (shown below). Doing so may damage or stain the CR encoder strip inside.
Opening above the platen
Upper cover
Bosses
"a"
Peep hole
PF encoder disk
"a"
"a"
"a"
"a"
"b"
Lower cover
"a": Taptite, bind B M4x12
"b": Taptite, cup B M3x10
6-39
"a"
Ink cartridge cover
(6_39_mini9e)
Confidential